Deep squats with alternating overhead reaches ► alternating cossack squats mit overhead reach

Topic
Power
Body part
Lower body
Muscle group
Oberschenkelmuskulatur (vorne), Rückenmuskulatur (oben), Oberschenkelmuskulatur (hinten)
Organization

Individual work

Duration (mm:ss)
00:00
Topic description

The movement begins in a very wide straddle stance with the toes pointing slightly outwards and the arms stretched vertically above the head, palms facing each other. The body weight shifts entirely to one side, whilst the buttocks are lowered backwards and downwards and the knee is bent as far as possible. The heel of the bent leg remains firmly on the floor. The other leg remains fully extended and rotates at the hip so that the toes point vertically towards the ceiling and the heel rests on the floor. From the lowest position, a powerful push-off is made through the heel back into the standing position. Immediately afterwards, the movement glides over to the opposite side without pausing, deeply bending the leg on that side, keeping the opposite leg fully extended with the toes pointing upwards, and pushing back up in a controlled manner.

Attention:

  • The heel of the bent supporting leg lifts off the floor.

  • The upper body leans far forwards and the arms droop downwards.

  • The knee of the supporting leg bends inwards sharply instead of moving over the foot.

  • The straight leg bends at the knee joint.

  • The toes of the straight leg actively point towards the ceiling.

  • The arms remain consistently stretched out behind the ears to straighten the thoracic spine.

  • The knee always follows the line of the middle toe of the bent leg.

Lighten:

  • Hold onto the suspension straps (TRX) or a measuring rod to support your body weight.

  • Do not stretch your arms above your head; instead, cross them in front of your chest.

  • Limit the range of motion and only lower yourself as far as both heels can remain flat on the ground.

Harden:

  • Hold a light weight plate or dumbbell overhead with your arms fully extended.

  • Pause for two seconds at the lowest point before initiating the pressing movement.

  • Change sides by gliding low along the floor without standing up fully.

Material

1 suspension trainer (TRX) / measuring stick ► to make the exercise easier
1 weight plate / dumbbell ► to make the exercise more difficult (additional weight)

QR-Code